Downloads

  1. Calibrator Certification Service 10/29/2014

    The Thermo Scientific Calibrator Certification Service compares and validates the Thermo Scientific Model 81i Mercury Calibrator to a NIST (National Institute of Standards and Technology) traceable Vendor Prime or Field Reference Generator. The calibration method is based on the Interim Draft Traceability Protocol as set forth by NIST and the Environmental Protection Agency (EPA).

  2. Calibrator Certification Service Datasheet 10/29/2014

    The Thermo Scientific™ Calibrator Certification Service compares and validates the Thermo Scientific™ Model 81i Mercury Calibrator, as well as the Thermo Scientific High Level Model 81iH and Low Level Model 81iL Calibrators, to a NIST- traceable Vendor Prime or Field Reference Generator.

  3. Best Kept Secret To Continuous Flare Stack Emission Monitoring 9/1/2014

    Continuous and accurate determination of total sulfur in flare gas (high and low ranges). Sulfur emissions in process heaters and flares can be successfully monitored by petroleum refineries requiring compliance. By Susan Harris, Thermo Fisher Scientific

  4. Performing Automated EPA Audits Using A DAS For The Thermo Scientific Model 81i Mercury Calibrator And Model 84i Permeation Source 9/1/2014

    Externally perform an EPA Audit on the Thermo ScientificTM Model 81i Mercury Calibrator by means of the Modbus protocol using the Model 84i Permeation Source in the Mercury Freedom System. By Jeremy Whorton and Bryan Marcotte, Thermo Fisher Scientific

  5. Thermo Scientific PM CEMS: A Dual-Sensing Technology 8/28/2014

    Particulate matter (PM) in flue gas can exhibit highly variable and dynamic characteristics depending on fuel type, combustion process and emission control parameters. The primary characteristics of PM are its mass concentration, size, and chemical composition. Its size influences emission transport and inhalation potential, while its chemistry largely defines its toxicity. By Kevin Goohs, R&D Manager Thermo Fisher Scientific, Franklin, MA, USA

  6. Model 5020i Sulfate Particulate Analyzer Datasheet 8/25/2014

    The Thermo Scientific Model 5020i Sulfate Particulate Analyzer (SPA) is a continuous, real-time, sulfate particulate analyzer that utilizes pulsed fluorescence technology and thermal reduction techniques.

  7. Model 82i Mercury Probe Controller 8/25/2014

    The Thermo Scientific Model 82i probe controller is microprocessor-driven and connected by an umbilical to the stack probe and mercury converter. The controller automates probe calibration and dynamic spiking, and confirms auto dilution. It also monitors probe temperature, measures flow rates and pressure in the sampling loop, and enables automated filter blowback.

  8. Model 82i Mercury Probe Controller Datasheet 8/25/2014

    The Thermo Scientific™ Model 82i Mercury Probe Controller is one of the four major components of the Mercury Freedom System.

  9. Model 81i Mercury Calibrator Datasheet 8/25/2014

    The Thermo Scientific™ Model 81i Mercury Calibrator is one of the four major components of the Mercury Freedom System.

  10. Model 80i Mercury Analyzer 8/25/2014

    The Thermo Scientific Model 80i analyzer uses an advanced cold vapor atomic fluorescence technology. This technology enables the Model 80i analyzer to provide continuous sample measurement, with no additional gases or accumulations required and virtually no interference from SO2. High sensitivity allows high sample dilution reducing moisture, heat, and interfering pollutants.