Product/Service

WATERTRAK™ Reverse Osmosis

Source: Aquatech International Corporation

reverseosmosis
Reverse Osmosis uses a semi-permeable spiral wound element to remove up to 99% of dissolved solids and bacteria from the feed water source

Click Here To Download:
Datasheet: WATERTRAK™ Reverse Osmosis

Reverse Osmosis (RO) uses a semi-permeable spiral wound element to remove up to 99% of dissolved solids (TDS) and bacteria from the feed water source. A high pressure feed pump forces raw water into thin film membrane layers thus allowing the permeate product water to collect in the center tube of the RO element. Water containing impurities and salts remain on the outside of the RO element and are rejected on the opposite side of the feed water inlet. As the pressure in the membrane increases, the permeate product and the rejected solids will increase. The sizing of the RO system will greatly vary based upon the concentration of dissolved solids in the feed water. Systems can be provided with single pass or dual pass depending on water quality requirement.

Features

  • PLC Control
  • 316SS High Pressure Piping
  • FRP Pressure Vessels
  • High Pressure Pump Mounted on RO Skid
  • Four and Eight Inch Pressure Vessels
  • Operating Pressures up to 600 psi
  • Spiral Wound Membrane Elements
  • Single or Double Pass

Click Here To Download:
Datasheet: WATERTRAK™ Reverse Osmosis