Product/Service

Total Instrument Manager

Source: Esafetygear.com (virtual properties of patchgear.com)
The Total Instrument Manager, or TIM System software, is designed to fully calibrate up to four instruments at the same time, with only one computer and four TIM Control Centers
The Total Instrument Manager, or TIM System software, is designed to fully calibrate up to four instruments at the same time, with only one computer and four TIM Control Centers. After an instrument has been bump-tested or calibrated, the TIM System will immediately display and print detailed results -- not only a pass or fail, but also results for each sensor. The TIM System also features a password identification system and a user-friendly archive of all past instrument calibrations that allows you to refer to and report on past calibration results. This model comes with computer without data docking module or regulator.

Designed to operated on a standard IBM-compatible PC. Minimum requirements are a Pentium processor, 16 MB RAM, a 30 MB hard drive and a 3.5" 1.44 MB floppy drive. The software is compatible with Windows 95.

Esafetygear.com (virtual properties of patchgear.com), #201 200 Rivercrest Dr. S.E., Calgary, AB T2C 2X5. Tel: 888-310-2121; Fax: 403-236-7012.