Series "E"

Our Series "E" pre-insulated riser clamps are intended for installation on vertical surfaces fro the restraint of downward or downward and upward loads. These clamps require the field welding of factory supplied thrust plates against the upper side or the upper and lower side of the clamp. Because of the insulated design there is no metal to metal to metal contact thus temperatures are maintained inside the pipe. These riser clamps can be installed onto spring retainers or welded onto a vertical surface. This series may be used in conjunction with spring hangers. Designs available for temperature ranges of -325 to 1800° F.

Please consult factory if your requirements are other than those shown below. We are committed to providing the most economical and appropriate insulated pipe supports to satisfy your requirements.

Shaw Pipe Shields Inc., 1001 Aldridge Road, Vacaville, CA 95688. Tel: 707-447-5014; Fax: 707-447-4641.