Series "C"

Our Series "C" pre-insulated friction and positive pipe anchors are intended to stop axial, lateral and vertical movement.

Models C3000 through C3300 are designed for relatively light axial forces and infrequent thermal cycling. This anchor does not need thrust plates welded to the pipe making this the easiest anchor to install. This anchor is designed for use on pipe conveying almost anything including hot and cold water, steam, air, gas or dual temperature applications. Please consult the factory for higher load ratings or thermal cycling.

C4000 through C4300 are positive anchor for heavy axial forces. Positive anchors require the welding of thrust plates to the pipe. The thrust plates and welding instructions are supplied to the customer by the factory. The number of plates and their position is dictated by the size and movement to be restrained. Higher load rating and 6 way positive anchors are available by design (please consult factory).

Our pipe anchors can also be designed to act as a directional restraint. Higher load ratings and 6-way positive anchors are available by design. Designs available for temperature ranges of -325 to 1800° F.

Please consult factory if your requirements are other than those shown below. We are committed to providing the most economical and appropriate insulated pipe supports to satisfy your requirements.

Shaw Pipe Shields Inc., 1001 Aldridge Road, Vacaville, CA 95688. Tel: 707-447-5014; Fax: 707-447-4641.