Support brackets molded of propylene bolt to the tank walls with epoxy anchors and can be repositioned either left or right if rebar is encountered during drilling. A fixed bracket is standard, and adjustable bracket, which can make installation easier by allowing two inches of vertical adjustment, is available. The heart of the system is a pultruded fiberglass-reinforced-plastic (FRP) J-shaped member designed specifically for this application. Twenty-foot-long sections of this component slide on to two brackets per section and into place. Molded poly splice bats connect the J-shaped members with four bolts per splice, and two poly stops per track length hold the track in position with one bolt each. These stops are positioned against the brackets at opposite ends of the track length. Ten-foot-long sections of the UHMW wear strip slide on to the J-shaped member and are retained in position by a stop. Fastened with one bolt, the stop fits into a notch in the side of the wear strip. N/Aany%>, 400 High Point Dr., Chalfont, PA 18914. Tel: 215-822-4300.