Liquicap T FMI21 Datasheet
Application
The Liquicap T sensor is used in conductive liquids (greater than 30 μS/cm) for continuous level measurement and is preconfigured from factory 0 % to 100 % to probe length ordered.
In conductive liquids greater than 30 μS/cm, the measurement is independent of the dc-value (dielectric constant) of the liquid. It can also be used in Ex areas, Zone 2.
The Liquicap T is particularly suited to the following applications:
- Small measuring ranges (greater than 6" / 150 mm)
- Cistern measurements
- Aggressive liquids (many acids and alkalis)
- Independent of the tank material (plastic, stainless steel or concrete) or the tank shape
Used in conjunction with the Fieldgate FXA320 (remote measured value interrogation using Internet technology), Liquicap T is an ideal solution for inventorying material and optimizing logistics (inventory control).
Your benefits
- Safe function regardless of tank geometry thanks to probe design
- No calibration necessary (preconfigured from factory 0 % to 100 % to probe length ordered)
- High quality, non-corrosive materials (carbon fibre, stainless steel) for use in aggressive liquids and liquids which present a hazard to water (WHG-approved (German Water Resources Law))
- No moving parts in tank - long operating life - dependable function without wear
- Cost-effective solution for continuous measurement of levels in conductive liquids
- Optimized storage by simply shortening the probe rods on site (probe shortening kit)
Get unlimited access to:
Enter your credentials below to log in. Not yet a member of Power Online? Subscribe today.